Table of Contents
Advertisement
RealPresence Collaboration Server (RMX) 4000 Hardware Guide
Safety Requirements
This section describes the requirements your site must meet for safe installation and
operation of the system.
Site Safety Requirements
For your protection, please read these safety instructions completely before operating the
equipment.
•
•
•
•
•
•
•
•
•
•
•
•
General Installation Precautions
Attention:
The RMX 4000 can weigh up to 40 kg when all slots are occupied. Two people are required to lift the
MCU out of the box and also when installing it in a rack.
•
•
•
1-6
Look carefully for potential hazards in your work area: moist floors, ungrounded
power cables, frayed power cords, missing safety grounds and so forth.
Locate the main circuit breaker within the room.
Locate the emergency power OFF switch within the room.
Never assume that power is disconnected from a circuit.
Use only the power cords supplied with the system.
Each power cord should only be connected to a power outlet that has a protective
ground contact.
Ensure that power cords are easily accessible from the back of the system at all times.
Place the equipment in a well-ventilated area where the vents are free from obstruction.
Do not place heavy objects directly on top of the RMX 4000 unit.
Do not use liquids around your equipment.
Keep the area around the RMX 4000 clean and free of clutter.
Decide on a suitable location for the equipment rack that will hold the RMX 4000 unit. It
should be situated in a clean, dust-free area that is well ventilated. Avoid areas where
heat, electrical noise and electromagnetic fields are generated. You will also need it
placed near a grounded power outlet.
Use a regulating uninterruptable power supply (UPS) to protect the RMX 4000 from
power surges and voltage spikes, to keep your MCU operating in case of a power
failure. The RMX 4000 requires either two (DC) or three (AC) power supply cables, each
connected to a power supply.
Allow the power supply units to cool before touching them.
When handling electronic components, standard anti-static precautions must be
observed:
— Wear a grounding strap
— Handle cards by their edges only and do not touch their components or connector
pins
— Keep components in anti-static bags, when not installed in the RMX 4000
Polycom, Inc.
Advertisement
Table of Contents
