Error Message: Adjust Opt3 Bin - MINOLTA-QMS magicolor 330 Service Manual

Large-capacity input feeder
Table of Contents

Advertisement

4.6

Error Message: Adjust OPT3 Bin

There is a problem with OPT3 bin.
Logic control on the MCU PWB did not detect a Paper Tray installed i OPT3 bin.
Step
SUSPECT COMPONENTS
The following components are associated with this specific
problem. One or more of these components may have failed
partially or completely. If you cannot isolate the problem using
this FIP , replace each component listed below, one at a time,
until the problem disappears.
• Wiring and connectors linking the LCIF to the Base Engine
• Wiring and connectors linking the components
1
PAPER TRAY INSPECTION
1. Remove the Paper Tray from OPT3 bin.
2. Inspect the Size Actuators at the rear of the Tray.
Are the Actuators intact and free of damage?
2
Replace the OPT2 bin Size Switch Assembly (LCIF DRP 6.23)
Does the error message still appear?
3
Replace the Feeder PWB (LCIF DRP 6.10)
Does the error message still appear?
4
Replace the MCU PWB (Base Engine DRP 6.123)
Does the error message still appear?
LCIF-32
Actions and Question
magicolor 330 Large-Capacity Input Feeder Service Manual
Yes
Go to step 2
Replace
Paper Tray.
Go to step 3
Problem
solved
Go to step 4
Problem
solved
Go
to
sus-
Problem
pect
compo-
solved
nents
No
the

Advertisement

Table of Contents
loading

Table of Contents