MINOLTA-QMS magicolor 330 Service Manual page 55

DRP 7.2 Large Capacity Input Feeder (PL20.1.1)
Removal
1. Lock down the four LCIF casters.
2. Remove the Option Harness Cover from the printer Rear Cover.
3. Disconnect the plugs that are located under the Option Harness Cover.
4. Slide OPT1 Tray out of the LCIF so you can access the two thumbscrews that are located at the top- front
of the LCIF.
5. Loosen the two thumbscrews that secure the LCIF to the printer frame.
6. Slide OPT1 Tray into the LCIF.
7. With the help of three other people, carefully lift the printer off of the LCIF.
The print engine is extremely heavy. Lifting the print engine is a four person job.
Do not attempt to lift the print engine without help.
WARNING
8. Place the base printer on a flat and stable work surface.
Replacement
1. Lock down the four LCIF casters.
2. With the help of three other people, lower the printer onto the LCIF making sure the locating pins on the top
of the LCIF slide into the locating holes in the bottom of the printer frame.
3. Slide OPT1 Tray out of the LCIF.
4. Tighten the two thumbscrews, located at the top-front of the LCIF, to secure the LCIF to the printer frame.
5. Slide OPT1 Tray into the LCIF.
6. Reconnect the plugs into the jacks that are located under the Option Harness Cover.
7. Reinstall the Option Harness Cover to the printer Rear Cover.
8. Unlock the four LCIF casters.
magicolor 330 Large-Capacity Input Feeder Service Manual LCIF-51