MINOLTA-QMS magicolor 330 Service Manual page 93

DRP 7.21 Turn Roll Assembly (PL22.2.24)
Use this procedure to remove and replace the Turn Roll Assembly for OPT1 Tray, OPT2 Tray, or OPT3 Tray of
the LCIF.
Removal
1. Remove the Turn Clutch (DRP 7.16).
2. Remove the LCIF Drive Assembly (DRP 7.15).
3. Place the LCIF Drive Assembly on a flat and stable work surface.
4. Remove the two screws securing the Turn Cover to the LCIF Drive Assembly and remove the Turn Cover
(Figure 1).
5. Remove the E ring securing the rear of the Turn Roll shaft to the rear bearing (Figure 2).
6. Remove the E ring securing the front of the Turn Roll shaft to the front bearing.
7. Slide the Turn Roll Assembly shaft far enough to the rear so the front of the shaft clears the front bearing
and remove the Turn Roll Assembly.
Replacement
1. Insert the rear of the Turn Roll Assembly shaft into the cutout in the rear of the LCIF Drive Assembly.
2. Insert the front of the Turn Roll Assembly shaft into the cutout in the front of the LCIF Drive Assembly.
3. Slide the front bearing, lip facing out, over the front end of the Turn Roll shaft and seat the bearing into the
cutout in the LCIF Drive Assembly frame.
4. Slide the rear bearing, lip facing out, over the front end of the Turn Roll shaft and seat the bearing into the
cutout in the LCIF Drive Assembly frame.
5. Use an E ring to secure the rear of the Turn Roll shaft to the rear bearing.
6. Use an E ring to secure the front of the Turn Roll shaft to the front bearing.
7. Reinstall the Turn Cover onto the LCIF Drive Assembly and use two screws to secure the Cover.
8. Reinstall the LCIF Drive Assembly (DRP 7.15).
9. Reinstall the Turn Clutch (DRP 7.16).
magicolor 330 Large-Capacity Input Feeder Service Manual LCIF-89