How To Follow A Fip - MINOLTA-QMS magicolor 330 Service Manual

3.2

How to Follow a FIP

1. Each numbered step in a FIP instructs you to perform a certain action or procedure.
2. The action box may contain additional information and numbered substeps you must follow to perform the
action.
3. The action is followed by a question.
4. If your response to the question is Yes, then follow the instructions for a Yes reply.
5. If your response to the question is No, then follow the instructions for a No reply.
6. FIPs may ask you to take voltage readings at certain test points within the LCIF or within the printer.
Sections 7 and 10 contain information on test point locations and signal names.
7. FIPs often ask you to replace a LCIF component. Section 7, "Disassembly and Reassembly Procedures,"
provides you detailed steps for removing and replacing all major parts of the LCIF.
2
NO PAPER SENSOR TEST
1. Enter Diagnostics and test Tray 1 No Paper Sensor.
2. Slide Tray 1 out of the printer.
3. Manually actuate and deactuate Tray 1 No Paper Sensor.
Does the Diagnostics Status Window display "actuated"
when you manually actuate the sensor?
·
Step number
·
Action with substeps, additional information, and a question.
LCIF-22
·
Action to take if the answer to the question is YES
·
Action to take if the answer to the question is N
magicolor 330 Large-Capacity Input Feeder Service Manual
Go to step 3 Replace the No
Paper Sensor
Assembly
(DRP 6.78)