How To Use The Fip Flowchart - MINOLTA-QMS magicolor 330 Service Manual

3.1

How to Use the FIP Flowchart

If you used the Service Flowchart, it should have directed you to this section. Follow the FIP Flowchart located
at the end of this section to analyze your Large Capacity Input Feeder problem.
1. If the printer exhibits an error message, use the FIP Flowchart to locate the correct FIP to resolve the prob-
lem.
2. If you have an LCIF operation problem; go to the LCIF PERFORMANCE box.
3. Follow the arrow leading from your problem box to the individual Primary FIP (Fault Isolation Procedure)
that corresponds to your error message or LCIF operation problem.
4. Follow the instructions presented in the FIP.
5. If a FIP instructs you to perform a diagnostic test, refer to Section 8 Running Printer Diagnostics .
6. Voltage and resistance values presented in the FIPs are an approximation. Actual readings may vary from
the stated values.
7. Primary FIPs may direct you to a Secondar y FIP.
magicolor 330 Large-Capacity Input Feeder Service Manual LCIF-21