Working with the printer
Cancel the current job
Use the following procedure whenever you want to cancel the current job.
1
Hold down the [CONTROL BUTTON] for more than 5 seconds.
2
After all the indicators are lit, release the panel button to cancel the
print job.
Printing out the configuration page
Print out the configuration page in order to check the configuration of your
printer.
1
Make sure that:
❍
the "Fault" and "Paper" lamps are not on, and
❍
the "Stand-by" lamp is on constantly.
2
Press the [CONTROL BUTTON] briefly.
The configuration page is now printed out.
Continuing a print job after an error message
Continue the print job after the following error messages:
✔
when the print job is too complex and the memory capacity of the
printer is inadequate;
✔
when there is no more paper in the feed trays;
✔
when paper of a different format to that set in the printer driver was fed
into the printer.
1
Make sure that one of the above errors has occurred.
2
Press the [CONTROL BUTTON] in order to operate the page feed.
The print job continues.
Check the print-out!
If you have continued a print job after an error message, then check
the print-out. It is often the case that not all pages required are printed
out.
PagePro 4100GN
9
9-5