MINOLTA-QMS magicolor 330 Service Manual page 85

DRP 7.17 Turn Clutch (PL22.2.26)
Use this procedure to remove and replace the Turn Clutch for OPT1 Tray, OPT2 Tray, or OPT3 Tray of the LCIF.
Removal
1. Remove the LCIF Rear Cover (DRP 7.2).
2. Free the Turn Clutch wire harness from the wire clamp that is located on the LCIF frame.
3. Disconnect the Turn Clutch P/J from the Feeder PWB.
4. Disconnect the E ring securing the Turn Cl u tch to the Turn Roll shaft and remove the Clutch.
Replacement
1. Slide the Turn Clutch onto the Turn Roll shaft making sure the metal key on the frame fits through the notch
on the Clutch.
2. Use an E ring to secure the Clutch to the shaft.
3. Reconnect the Turn Clutch P/J to the Feeder PWB.
4. Hook the Turn Clutch wire harness into the wire clamp that is located on the LCIF frame.
5. Reinstall the LCIF Rear Cover (DRP 7.2).
magicolor 330 Large-Capacity Input Feeder Service Manual LCIF-81