MINOLTA-QMS magicolor 330 Service Manual page 99

DRP 7.24 Tray No Paper Sensor (PL22.2.31)
Use this procedure to remove the Tray No Paper Sensor for OPT1 Tray, OPT2 Tray, or OPT3 Tray of the LCIF.
Removal
1. Remove the LCIF Drive Assembly (DRP 7.15).
2. Place the LCIF Drive Assembly on a flat and stable work surface.
3. Disconnect the P/J from the No Paper Sensor.
4. Squeeze together the three latches securing the No Paper Sensor to the Sensor Bracket and remove the
Sensor .
Replacement
1. Position the No Paper Sensor Assembly against the cutout in the Sensor Bracket.
2. Push the Sensor into the cutout.
The latches snap into place.
3. Reconnect the P/J to the No Paper Sensor.
4. Reinstall the LCIF Drive Assembly (DRP 7.15).
magicolor 330 Large-Capacity Input Feeder Service Manual LCIF-95