4.1 Error Message: Put < Size > Paper In Opt3 Bin - MINOLTA-QMS magicolor 330 Service Manual

4.1 Error Message: Put < Size > Paper in OPT3 Bin
OPT3 bin tray is out of paper.
Logic control on the MCU PWB detected that the No Paper Sensor in OPT3 Bin is actuated. The Engine Diag-
nostic Menu may refer to the the OPT3 Bin no paper sensor as Tray 4 no paper sensor.
Step
SUSPECT COMPONENTS
The following components are associated with this specific
problem. One or more of these components may have failed
partially or completely. If you cannot isolate the problem using
this FIP , replace each component listed below, one at a time,
until the problem disappears.
• Wiring and connectors linking the LCIF with the MCU PWB
1 LCIF TRAY INSPECTION
Slide OPT3 tray out of the LCIF.
Is the Tray out of paper?
2
NO PAPER SENSOR TEST
1. Enter Diagnostics and test OPT3/Tray 4 No Paper Sensor.
2. Manually actuate and deactuate the No Paper Sensor.
Is "actuated" displayed when you manually actuate the
sensor? And, is "not actuated" displayed when you manu-
ally deactuate the sensor?
3
Replace the Feeder PWB (LCIF DRP 6.10)
Does the error message still appear?
4
Replace the MCU PWB (Base Engine DRP 6.123)
Does the error message still appear?
magicolor 330 Large-Capacity Input Feeder Service Manual
Actions and Question Yes
Load paper Go to step 2
into the Tray.
Go to step 3 Replac
OPT3/Tray 4
No Paper
Sensor
Assembly
(LCIF DRP
6.23)
Go to step 4 Problem
Solved
Go to sus- Problem
pect compo- Solved
nents
No
LCIF-27