Drp 7.14 Size Switch Assemblies (Pl22.1.15) - MINOLTA-QMS magicolor 330 Service Manual

DRP 7.14 Size Switch Assemblies (PL22.1.15)

Use this procedure to remove and replace the Size Switch Assembly for OPT1 Tray, OPT2 Tray, or OPT3 Tray
of the LCIF.
Removal
1. Remove the LCIF Rear Cover (DRP 7.2).
2. Disconnect P/J 172, P/J 177, and P/J 181 from the three Size Switches that are attached to the Size
Bracket.
3. Loosen, but do not remove, the screw securing the bottom of the Size Bracket to the LCIF frame.
4. Remove the screw securing the top of the Size Bracket to the LCIF frame and remove the Size Bracket,
along with the three attached Size Switches, from the frame (Figure 1).
5. Remove the screw securing the Size Switch Assembly that you want to remove and lift the Assembly off of
the Bracket (Figure 2).
Replacement
1. Position the Size Switch Assembly against the Size Bracket so the P/J connector on the Assembly pro-
trudes through the cutout in the Bracket.
2. Reposition the Size Switch Assembly so the locating tabs on the bottom of the Assembly fit though the
locating holes in the Bracket.
3. Use one screw to secure the Size Switch Assembly to the Size Bracket.
4. Slide the bottom of the Size Bracket behind the loosened screw that is located at the bottom of the LCIF
frame.
5. Reposition the Size Bracket so the top screw hole in the Assembly lines up with the top screw hole in the
LCIF frame.
6. Use one screw to secure the top of the Size Bracket to the LCIF frame.
7. Tighten the bottom screw to secure the bottom of the Size Bracket to the LCIF frame.
8. Reconnect P/J 172, P/J 177, and P/J 181 to the three Size Switches.
9. Reinstall the LCIF Rear Cover (DRP 7.2).
magicolor 330 Large-Capacity Input Feeder Service Manual LCIF-75