Sony DVCAM DSR-PDX10 Service Manual page 450

Connecting your camcorder to your computer using the USB cable
– For Windows users
If you cannot install the USB driver
The USB driver has been registered incorrectly as your computer was connected to your
camcorder before installation of the USB driver was completed. Perform the following
procedure to correctly install the USB driver.
Viewing images recorded on a tape
Step 1: Uninstall the incorrect USB driver
1 Turn on your computer and allow Windows to load.
2 Connect the AC power adaptor, and set the POWER switch to VCR.
3 Connect the USB connector on your computer to the
4 Open your computer's "Device Manager."
5 Select and delete the underlined devices below.
198
camcorder using the USB cable supplied with your camcorder.
Windows XP Home Edition/Professional:
Select "Start" t "Control Panel" t "System" t "Hardware," and click the
"Device manager" button.
If there is no "System" inside "Pick a category" after clicking "Control Panel,"
click "Switch to classic view" instead.
Windows 2000 Professional:
Select "My Computer" t "Control Panel" t "System" t "Hardware" tab,
and click the "Device Manager" button.
Windows 98 SE/Windows Me:
Select "My Computer" t "Control Panel" t "System," and click "Device
Manager."
Windows 98SE
(USB) jack on your
Windows Me