Sony DVCAM DSR-PDX10 Service Manual page 211

DSR-PDX10/PDX10P
2-3-10. TG6 Guide Zenith Adjustment
1. Adjustment procedure
1) Remove the drum referring to section 2-3-1. Install the dummy
drum (Ref. No. J-22).
2) Install the TG36 gauge (Ref. No. J-23) on top of the dummy
drum. Adjust the slant of the TG6 guide.
3) Rotate the slant adjustment zenith screw until the TG6 guide
and TG36 gauge (Ref. No. J-23) become parallel.
4) Remove all the jigs. Attach the original drum back in its original
position referring to section 2-3-1.
5) Clean the TG5 and TG6 guides referring to section 2-2-2.
6) Perform tape path adjustment. (Refer to section 2-4, "Tape
Path Adjustment".)
TG5 guide
TG36 gauge
Dummy drum
TG6 guide and TG36 gauge
must be parallel.
TG6 guide
TG36 gauge
TG6 guide
Slant adjustment zenith screw
Fig. 6-2-15.
2-3-11. LS Cam Plate Position Adjustment
1. Adjustment procedure
1) Loosen the LS cam fixing screw (M1.4 × 4) 1 by 180 degrees.
2) Establish the [STOP] mode.
3) While pressing down the center of the LS chassis block assy
with force of 100 to 200 gf (0.98 to 1.96 N), move the LS cam
plate toward the S-reel side and tighten the LS cam plate fixing
screw (M1.4 × 4) 1 with force of 500 to 1000 gf (4.9 to 9.8
N).
Tightening torque: 0.059 to 0.01 N•m (0.6 kg•cm).
Press the LS block assy
with force of 100 to 200 gf
(0.98 to 1.96 N)
Mechanism chassis block assy
6-56
LS cam plate fixing screw
Dowel of LS arm
LS cam plate
Press the LS cam plate
with force of 500 to 1000 gf
(4.9 to 9.8 N)
Fig. 6-2-16.