Sony DVCAM DSR-PDX10 Service Manual page 220

2-3-20. DC Motor (Capstan), Conversion Gear, Relay Gear
1. Removal procedure
Remove the three screws (M1.4 × 2) 1.
1)
2) Remove DC motor (capstan). Remove belt from the pulley of
conversion gear.
3) Remove conversion gear.
4) Remove relay gear.
Conversion gear
Relay gear shaft
Conversion gear shaft
When attaching it, coat the hatched
Belt must be completely
free from twist or stain
when it is installed.
Relay gear
portion with grease.
Fig. 6-2-25.
6-65
2. Attachment procedure
1) Coat relay gear shaft and conversion gear shaft with grease (1/
8 drop). (Amount of grease must be strictly controlled.)
2) With the larger gear of the relay gear positioned down, attach
the relay gear to the relay gear shaft.
3) With the pulley side of the conversion gear positioned up,
engage the conversion gear teeth with the relay gear teeth, and
install them.
4) Before installing the DC motor (capstan (including belt)), check
that belt is not twisted. Hook a belt on the pulley block of
conversion gear. Align three shafts with corresponding holes.
At this moment, confirm that belt does not override on the shaft.
Install DC motor (capstan) with three screws (M1.4 × 2) 1 in
5)
the order of A, B and C.
A, B, C tightening torque
A tightening torque: 0.059 ± 0.01 N•m (0.6 kg•cm)
B and C tightening torque: 0.038 ± 0.01 N•m (0.4 kg•cm)
Note: Be careful that gears and belts are not damaged or dust is not attached.
Be careful also not to splash grease.
1Three screws (M1.4 × 2)
A
B
C
DSR-PDX10/PDX10P
DC motor (capstan)
(including belt)