Sony DVCAM DSR-PDX10 Service Manual page 271

Step 1 Preparing the power supply
Connecting to a wall socket
When you use your camcorder for a long time, we recommend that you power it from a
wall socket using the AC power adaptor.
(1) Open the DC IN jack cover. Connect the AC power adaptor supplied with
your camcorder to the DC IN jack on your camcorder with the plug's v mark
facing up.
(2) Connect the mains lead to the AC power adaptor.
(3) Connect the mains lead to a wall socket.
1
PRECAUTION
The set is not disconnected from the AC power supply (the mains) as long as it is
connected to the wall socket, even if the set itself has been turned off.
Notes
•The AC power adaptor can supply power even if the battery pack is attached to your
camcorder.
•The DC IN jack has "source priority." This means that the battery pack cannot supply
any power if the mains lead is connected to the DC IN jack, even when the mains lead
is not plugged into a wall socket.
Using a car battery
Use Sony Car Battery Adaptor (optional).
Refer to the operating instructions of the Car Battery Adaptor for further information.
2,3
19