Sony DVCAM DSR-PDX10 Service Manual page 161

DSR-PDX10/PDX10P
1-1-2. Preparations
Note1: For details of how remove the cabinet and boards, refer to "2.
DISASSEMBLY".
Note2: When performing only the adjustments, the lens block and boards
need not be disassembled.
Note3: Before performing the adjustments, check the data of page: 0,
address: 10 is "00". If not, set data: 00 to this address.
1) Connect the equipment for adjustments according to Fig. 6-1-3.
Note4: As removing the cabinet (R) assembly (removing CN5203 of the
CK-134 board) means removing the lithium 3V power supply
(BT5201 on the CK-134 board), data such as date, time, user-set
menus will be lost. After completing adjustments, reset these data.
But the self-diagnosis data and the data on history of use (total
drum rotation time etc.) will be kept even if the lithium 3V power
supply is removed. (Refer to "6-4.Service Mode" for the self-
diagnosis data and the data on history of use.)
Note5: Setting the "Forced Camera Power ON" Mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 01, and press the PAUSE
button.
The above procedure will enable the camera power to be turned
on with the control switch block (PS-1870) removed. After
completing adjustments, be sure to exit the "Forced Camera Power
ON Mode".
Note6: Exiting the "Forced Camera Power ON" Mode
1) Select page: 0, address: 01, and set data: 01.
2) Select page: D, address: 10, set data: 00, and press the PAUSE
button.
3) Select page: 0, address: 01, and set data: 00.
Pattern box
Front of the lens
6-6
1m
Fig. 6-1-2.