Sony DVCAM DSR-PDX10 Service Manual page 218

2-3-18. Gear Cover B, GL Driving Gear
1. Removal procedure
Remove the screw (M1.4 × 2) 1.
1)
2) Remove the gear cover B in the direction of the arrow A.
3) Remove the GL drive gear.
Fig. 2
Coaster-S block assy
Cam gear A
When attaching it, coat the hatched
with grease.
Cam gear A
Fig. 1
GL drive shaft
Hole of the GL
drive gear
Hole of mechanism
Cam gear A
chassis
Phase adjustment of the GL drive gear
Coaster-T block assy
Cam gear B
3 GL drive gear
portion
In-phase markings of the
coaster-T block assy
Hole of cam
gear B
Cam gear B
Fig. 6-2-23.
2. Attachment procedure
1) Coat the cam gear A and the GL drive gear with grease (1/2
drop). (Refer to Fig. 2.)
2) Refer to Fig. 1. While adjusting phase of the GL drive gear as
shown, insert the GL drive gear into the GL drive shaft. (Insert
it while moving the GL drive gear in the clockwise direction.)
3) Insert the two claws of the gear cover B into the square holes
of mechanism chassis.
Fix the GL drive shaft with the screw (M1.4 × 2) 1. Be sure
4)
that the gear cover B must not have any play.
Tightening torque: 0.059 ± 0.01 N•m (0.6 kg•cm)
1 Screw (M1.4 × 2)
A
GL drive gear
Coaster-S block assy
6-63
DSR-PDX10/PDX10P
Gear cover B
Insert them into the
two grooves.
Coaster-T block assy
Cam gear B
GL drive shaft