Sony DVCAM DSR-PDX10 Service Manual page 296

Playing back a tape
[a] Time code
[b] SteadyShot OFF
[c] Exposure mode
[d] White balance
[e] Gain
[f] Shutter speed
[g] Aperture value
Using the Remote Commander
Press DATA CODE on the Remote Commander in the playback.
The display changes as follows when you press the DATA CODE on the Remote
Commander:
date/time t various settings (SteadyShot, exposure, white balance, gain, shutter
speed, aperture value) t no indicator
To not display various settings
Set DATA CODE to DATE in the menu settings (p. 222).
The display changes as follows when you press DATA CODE :
date/time y no indicator
Various settings
Various settings are your camcorder's information when you have recorded. In the
recording, the various settings will not be displayed.
When you use the data code, bars (-- -- --) appear if:
– A blank portion of the tape is being played back.
– The tape is unreadable due to tape damage or noise.
– The tape was recorded by a camcorder without the date and time set.
Data code
When you connect your camcorder to the TV, the data code appears on the TV screen.
Remaining battery time indicator during playback
The indicator indicates the approximate continuous playback time. The indicator may
not be correct, depending on the conditions in which you are playing back. When you
close the LCD panel and open it again, it takes about one minute for the correct
remaining battery time to be displayed.
44
Date/time
40min
00:00:23:01
4 7 2002
12:05:56
Various settings
40min
00:00:23:01
AUTO
50 ATW
F1.8 9dB
[a]
[b]
[c]
[d]
[e]
[f]
[g]