Sony DVCAM DSR-PDX10 Service Manual page 222

2-3-22. Gear Cover A, FP-100 Flexible Wiring Board
1. Removal procedure
Remove the screw (M1.4 × 2) 1.
1)
2) Remove the gear cover A in the direction of the arrow A.
Remove the screw (M1.4 × 2.5) 2.
3)
4) Remove soldering from the motor terminal and FP-228 flexible
wiring board (DEW sensor) that are used to connect the FP-
100 flexible wiring board with the motor holder block assy.
5) Remove the motor holder block assy.
Align the U-groove
with the cam gear
A shaft.
FP-228 flexible wiring board
(DEW sensor)
Align the two points that are square
hole of chassis and round hole.
Note: Be careful not to override.
Phasing check
Gear cover A
Position where hole of the
gear is visible
Cam gear A shaft
When attaching it, coat the hatched
1 Screw (M1.4 × 2)
A
Motor holder
block assy
Deceleration gear
portion with grease.
2. Attachment procedure
1) Align the motor holder block assy position with the chassis
square hole and round hole. The press the motor holder block
assy with finger.
Note: Coat the worm shaft with grease (1/2 size of a rice gain).
Fix the motor holder block assy with the screw (M1.4 × 2.5)
2)
2.
Tightening torque: 0.059 ± 0.01 N•m (0.6 kg•cm)
3) Install the gear cover A as follows: Hook the shaft with the key
slot and align the U-groove with the cam gear A shaft. Confirm
at this time that there is a play.
4) Attach the gear cover A to the cam gear A shaft and fix them
with the screw (M1.4 × 2) 1.
Tightening torque: 0.059 ± 0.01 N•m (0.6 kg•cm)
5) Connect the FP-100 flexible wiring board with the motor holder
block assy (motor terminal and FP-228 flexible wiring board
(DEW sensor)) by soldering.
Note: Do not touch the DEW sensor.
Gear cover A
2 Screw (M1.4 × 2.5)
Soldering
Soldering point
point
Fig. 6-2-27.
6-67
DSR-PDX10/PDX10P
Deceleration gear A shaft
Gear cover A
FP-100 flexible wiring board
Motor holder block assy
Worm shaft