Sony DVCAM DSR-PDX10 Service Manual page 373

Setting time values
You can use time code or user bits for time data.
The time value is displayed on the LCD screen, in the viewfinder, or on the display
window. The time code and user bits can be set only in DVCAM mode.
The user bits are convenient when using multiple cameras at the same event.
When you record the picture, time code data will be recorded automatically.
Setting the time code value
(1) Set the POWER switch to CAMERA or VCR.
(2) Press MENU, then turn the SEL/PUSH EXEC dial to set TC MAKE in
PRESET, then press the dial.
(3) Turn the SEL/PUSH EXEC dial to select TC PRESET, then press the dial.
(4) Turn the SEL/PUSH EXEC dial to select PRESET, then press the dial.
(5) Set up the first two digits. Turn the SEL/PUSH EXEC dial to select the
number, then press the dial. The time code is set between 00:00:00:00 and
23:59:59:29.
(6) Repeat step 5 to set up the other digits.
2
MENU
3-5
TC / UB SET
TC PRESET
UB PRESET
TC RUN
TC MAKE REGEN
UB T I ME PRESET
RETURN
[MENU] : END
TC / UB SET
TC PRESET 00:00:00:00
UB PRESET
TC RUN
TC MAKE
UB T I ME
RETURN
TC / UB SET
TC PRESET 00:00:00:00
[MENU] : END UB PRESET
TC RUN RESET
TC MAKE PRESET
UB T I ME RETURN
RETURN
[MENU] : END
(continued on the following page)
to
TC / UB SET
TC PRESET
UB PRESET
TC RUN
TC MAKE
PRESET
UB T I ME
RETURN
[MENU] : END
TC / UB SET
TC PRESET
UB PRESET 01:00:00:00
TC RUN
TC MAKE
UB T I ME SET
RETURN CANCEL
[MENU] : END
121