Sony DVCAM DSR-PDX10 Service Manual page 204

2-3. Check, Adjustment and Replacement of Mechanical Parts
2-3-1. Drum
1. Removal procedure
Loosen the three screws (M1.4 × 2) 1 fixing the drum and
1)
remove the drum.
Drum (rear view)
Slot (reference hole A)
Hole (reference hole B)
2. Attachment procedure
1) Align the two reference holes A and B on the rear of the drum
with the position setting reference pins A and B of the drum
base assy.
Install the drum with the three screws (M1.4 × 2) 1 and tighten
2)
the screws in order from A, then B and finally C.
Tightening torque: 0.059 ± 0.01 N•m (0.6 kg•cm)
3) Clean the drum referring to section 2-2.
4) Perform the tape path adjustment. (Refer to section 2-4, "Tape
Path Adjustment".)
Drum
Reference pin A
C
Reference pin B
A
Fig. 6-2-6.
6-49
DSR-PDX10/PDX10P
Drum base block assy
B
1 Three screws (M1.4 × 2)