Sony DVCAM DSR-PDX10 Service Manual page 190

18. AF Laser Output Adjustment
Set the AF laser output to an appropriate level.
Subject Paper which reflection rate is 18%
(50cm from the front of the lens)(Note1)
Measurement Point Adjustment remote commander
Measuring Instrument
Adjustment Page F
Adjustment Address 7D to 83
Specified Value Data of address: 70 is "10" to "FF".
Data of address: 7E is "00" to "F0".
Data of address: 7F is "0A" to "FF".
Data of address: 82 is "33" to "4D".
Note1: Use the background paper (J-250-130-A) and the flash adjustment
box. (Refer to "1-1-3.Precaution".)
Note2: Any light other than the laser light should not light up the subject
Note3: Remove the lens hood.
Note4: This adjustment should be carried out upon completion of the
following adjustments.
"HALL Adjustment", "Flange Back Adjustment", "Auto White
Balance Standard Data Input", "F No. & ND Light Quantity
Standard Data Input".
Note5: The data of page: 0, address: 10 must be "00".
Note6: Check that the data of page: 6, address: 02 is "00". If not, to page:
6, address: 01, set data: 00, and press the PAUSE button.
Switch setting:
1) POWER .................................................................. CAMERA
2) STEADY SHOT (Menu display) ..................................... OFF
Adjusting method:
Order Page Address Data
1 0 01 01
2 6 30 02
3 6 01 AF
4
5 6 02
6 F 7D
7 F 7E
8 F 7F
9 F 82
Note7: The adjustment data will be automatically input to page: F, address:
7D to 83.
Processing after Completing Adjustments:
Order Page Address Data
1 6 01 00
2 6 30 00
3 0 01 00
Procedure
Set the data.
Set the data.
Set the data, and press PAUSE
button.
Check the laser light is output.
Check that the data is "01".
(Note7)
Check that the data is "10" to
"FF".
Check that the data is "00" to
"F0".
Check that the data is "0A" to
"FF".
Check that the data is "33" to
"4D".
Procedure
Set the data, and press PAUSE
button.
Set the data.
Set the data.
6-35
DSR-PDX10/PDX10P