Sony DVCAM DSR-PDX10 Service Manual page 206

2-3-3. Retainer Plate Assy, LED Retainer
1. Removal procedure
1) While pressing the claw of the LED retainer in the direction of
the arrow A, remove the LED retainer.
2) Remove the LED portion 2 of the FP-102 flexible wiring
board.
Remove the two screws (M1.4 × 1.4) 1.
3)
4) In order to remove the retainer plate assy, because it is hooked
with shaft A, shaft B and shaft C, remove the retainer plate
assy while moving it in the direction of the arrow B.
Notch A
Claw on top of TG1 assy
Shaft A
Retainer plate assy
Retainer plate assy
Notch B
Retainer plate assy
Brake-S pivot shaft
Shaft B
Shaft B
2 FP-102 flexible wiring board
LED retainer
1 Two screws
(M1.4 × 1.4)
B
TG1 ASSY
Shaft A
Fig. 6-2-8.
6-51
2. Attachment procedure
1) Hook shaft A, shaft B and shaft C on notch A, notch B and
notch C of the retainer plate assy in this order.
Attach the retainer plate assy with two screws (M1.4 × 1.4) 1.
2)
Tightening torque: 0.059 ± 0.01 N•m (0.6 kg•cm)
3) Route the FP-102 flexible wiring board as shown and install
the LED into the prism as shown.
4) Hook the LED retainer on D, attach it to E and fix them.
Routing the FP-102 flexible wiring board
D
LED
Prism
Flexible board is routed
under the LED retainer.
A
Shaft C
DSR-PDX10/PDX10P
LED retainer
E
Route it so that the
flexible board is placed
above the LED retainer.
2 FP-102 flexible wiring board
Notch C
Retainer plate assy
Brake-T pivot shaft
Shaft C