Sony DVCAM DSR-PDX10 Service Manual page 165

DSR-PDX10/PDX10P
1-2. INITIALIZATION OF 8, A, B, C, D, E, F, 1B, 1E,
1F PAGE DATA
Note: When reading or writing the 1B, 1E or 1F page data, select page: 0,
address: 10, and set data: 01, then select B, E or F page. The 1B, 1E
or 1F page can be chosen by this data setting.
After reading or writing, reset the data of page: 0, address: 10 to
"00".
[Connection of the power supply during the initialization of the
data.]
1) Connect the regulated power supply and the digital voltmeter
to the battery terminal as shown in Fig. 6-1-8.
2) Adjust the output voltage of the regulated power supply so that
the digital voltmeter display is 6.0 ± 0.1Vdc.
3) Turn off the power supply.
4) Turn on the HOLD switch of the adjusting remote commander.
5) Turn on the power supply.
6) Perform the initialization of the data.
Note: This is normal though the following message is indicated on the
LCD screen.
"FOR InfoLITHIUM BATTERY ONLY"
Digital voltmeter
[Initialization Procedure]
1.
2.
3.
4.
Regulated power supply
6.0 ± 0.1 Vdc
Fig. 6-1-8.
6-10
Initialization of A, D page data
Initialization of 8, C page data
Initialization of E, F, 1E, 1F page data
Initialization of B, 1B page data