Sony DVCAM DSR-PDX10 Service Manual page 199

DSR-PDX10/PDX10P
6-2. MECHANICAL SECTION ADJUSTMENT
2-1. Preparations for Check, Adjustment and Replacement of Mechanism Block
• Refer to the "SECTION 2 DISASSEMBLY" section for details of removing cabinets and printed wiring boards.
• When making any adjustment to a mechanism or replacing mechanical parts, be sure to use the Mode Selector II and select the appropriate
status of the mechanical deck such that the mechanical status is suitable for the desired work. Refer to section "2-5. Mode Selector II"
for details on how to enter the mode shown in a rectangle [
2-1-1. Cassette Compartment Assy, Damper Assy
1. Removal Procedure
1) Set the [EJ] mode.
2) When the cassette compartment moves up in the direction of
the arrow B, establish the [ULE] mode.
3 Release the two claws 1 and dowel of the damper assy and
remove the damper assy.
4) Remove the shaft of the holder arm from the damper arm.
5) Remove the two screws (M1.4 × 2) 2.
6) Lift up the LS frame in the direction of the arrow C.
7) Lift up the cassette compartment block assy in the direction of
the arrow A. While pushing the holder arm in the direction of
the inside arrow E, remove the cassette compartment block
assy.
Two screws (M1.4 × 2)
2
* Be careful not to
deform here.
While pressing
toward the inside
Holder arm
Cassette compartment
slide shaft
D
Cassette compartment
block assy
LS frame
C
LS frame pivots
(two pivots in the right and left)
E
Groove
LS chassis block assy
] mode in subsequent paragraphs of this manual.
2. Attachment procedure
1) Set the [ULE] mode.
2) Attach the holder arm of the cassette compartment block assy
to the cassette compartment slide shaft on both sides of the LS
chassis block assy from inside.
3) Install the LS frame pivot into the groove D of the LS chassis.
Drop down the LS frame in the direction opposite to C.
4) Hook the LS frame T-side bent portion on the LS chassis notch
F.
5) Attach the LS frame with two screws (M1.4 × 2) 2.
Tightening torque: 0.054 ± 0.01 N•m (0.6 kg•cm).
6) While inserting the damper shaft of the cassette compartment
block assy into slot of the damper arm, engage the two claws
1 with the notch of the LS chassis block assy, and fix the
dowel to the corresponding hole of the LS chassis block assy
respectively.
Note: Check that the two claws 1 and dowel do not come off.
B
LS chassis block assy
Damper assy
Cassette compartment
block assy
A
E
LS chassis block assy
Groove
D
Notch
F
Fig. 6-2-1.
6-44
Removal method of
damper assy
Holder arm
Claw
1
Dowel
Slot of damper arm
Claw
1
LS chassis block assy
Damper shaft
* Be careful not to
deform here.
While pressing
toward the inside
Holder arm
Cassette compartment
slide shaft
LS frame