Nord Drivesystems NORDAC FLEX SK 200E Series User Manual page 170

NORDAC FLEX (SK 200E ... SK 235E) – Users Manual for Frequency Inverters
Pos : 428 /Anleitungen/El ektr oni k/FU und Starter/5. Par ameter/Par ameter auflistung (P000 ...)/P400- P499/Parameter P402 – Abgleic h 0% [SK 2xxE] @ 2\mod_1346931798594_14638.doc x @ 42455 @ @ 1
P402
[-01]
Adjust: 0%
...
(analog input adjustment: 0%)
[-06]
-50.00 ... 50.00 V [-01]
{ all 0.00 }
[-02]
[-03]
[-04]
[-05]
[-06]
This parameter sets the voltage which should correspond to the minimum value of the selected
function for analog input 1 or 2. In the factory setting (setpoint) this value corresponds to the
setpoint set via P104 >Minimum frequency<.
Note
SK 2x0E
For the adjustment of the analog inputs integrated in the SK2x0E to the type of analog signals,
the following values must be set:
0 - 10V
2 - 10V
0 - 20mA
4 - 20mA
DIP switches: (please see chapter 4.3.2.3 "DIP switches, analog input (only SK 2x0E)")
SK xU4-IOE
Standardization to typical signals such as 0(2)-10 V or 0(4)-20 mA is carried out via the DIP
switch on the I/O-extension module. In this case, additional adjustment of parameters (P402) and
(P403) must not be carried out.
Pos : 429 /Allgemein/Allgemeingültig e Module/---------Seitenumbr uc h kompakt --------- @ 13\mod_1476369695906_0.doc x @ 2265496 @ @ 1
170
Ext. Analog in 1, AIN1 of the first I/O extension (SK xU4-IOE)
Ext. Analog in 2, AIN2 of the first I/O extension (SK xU4-IOE)
Ext. Al 1 2. IOE, "External analog input 1 2nd IOE", AIN1 of the second I/O extension
(SK xU4-IOE) (= analog input 3)
Ext. Al 2 2. IOE, "External analog input 2 2nd IOE", AIN2 of the second I/O extension
(SK xU4-IOE) (= analog input 4)
Analog input 1, Analog input 1 (only SK 200E, SK 210E)
Analog input 2, Analog input 2 (only SK 2x0E)
→ 0.00 V
→ 2.00 V
→ 0.00 V (enable internal resistance via DIP switch!)
→ 1.00 V (enable internal resistance via DIP switch!)
S
BU 0200 en-US-3118