Nord Drivesystems NORDAC FLEX SK 200E Series User Manual page 167

18 = Curve control, the master receives the prevailing speed from the slave via the external
19 = Servo mode torque, in servo mode ((P300)= "1") the motor torque can be set/limited
25 = Ratio gearing, "gear transmission factor", is a multiplier to compensate for the variable
26 =
30 = Motor temperature, enables measurement of motor temperature with a
33 = Setval.torque p.reg., "Setpoint torque process controller", for even distribution of torques
34 = d-corr. F Process -
35 = d-corr. Torque - (diameter correction, torque).
36 = d-corr. F+Torque -
*) Please refer to section 8.2 "Process controller"for further details about the PI and process
controller.
**) The limits of these values are formed by the parameters >minimum frequency auxiliary
setpoints< (P410) and the parameter >maximum frequency auxiliary setpoints< (P411), whereby
the limits defined by (P104) and (P105) cannot be undershot or overshot.
Pos : 424 /Allgemein/Allgemeingültig e Module/---------Seitenumbr uc h kompakt --------- @ 13\mod_1476369695906_0.doc x @ 2265496 @ @ 1
BU 0200 en-US-3118
analog input (P400 [-03] or P400 [-04]) or via the BUS (P546 [-01 .. -03]). The master
calculates the prevailing setpoint speed from its own speed, the slave speed and the
guide speed so that neither of the two drives travels faster than the guide speed in the
curve.
using this function. As of firmware version V1.3 this function is also without speed
feedback but it can be used at a lower quality.
transmission of a setpoint. E.g.: Setting of transmission between master and slave by
means of a potentiometer.
...reserved
, for Posicon, see
KTY-84 temperature sensor ( Section
to coupled drive units (e.g.: S roller drive). This function is also possible with the use of
ISD control.
BU0210
4.4 "KTY84-130 connection"
(diameter correction, frequency PI /process controller).
(diameter correction, frequency PI/process controller and
torque).
5 Parameter
).
167