Pos : 356 /Anleitungen/El ektr oni k/FU und Starter/5. Par ameter/Par ameter auflistung (P000 ...)/P200- P299/Parameter P216 – Zei t Boost Vorhalt @ 2\mod_1346931673560_14638.doc x @ 42281 @ @ 1

Time boost prectrl.

P216

(boost derivative action time)

0.0 ... 10.0 s

This parameter is used for 3 functions:

{ 0.0 }

Time limit

Only in linear characteristic curves (P211 = 0% and P212 = 0%).

Time limit for suppression of pulse switch-off (P537): enables heavy starting.

Time limit for suppression of switch-off on error in parameter (P401), setting { 05 } "0 - 10 V

with switch-off on error 2"

Pos : 357 /Anleitungen/El ektr oni k/FU und Starter/5. Par ameter/Par ameter auflistung (P000 ...)/P200- P299/Parameter P217 – Sc hwi ngungs dämpfung @ 0\mod_1327590520707_14638.doc x @ 14929 @ @ 1

Oscillation damping

P217

(oscillation damping)

0 ... 400 %

No-load resonance vibrations can be damped with oscillation damping. Parameter 217 is a

measure of the damping capacity.

{ 10 }

In oscillation damping the oscillation component is filtered out of the torque current by means of a

high-pass filter. This is amplified by P217 and inverted to the output frequency.

The limit for the applied value is also proportional to P217. The time constant for the high-pass filter

depends on P213. For higher values of P213 the time constant is lower.

With a value of 10% for P217, a maximum of ± 0.045 Hz is applied. With 400% in P217, this

corresponds to ± 1.8 Hz.

The function is not active in "Servo mode, P300".

Pos : 358 /Anleitungen/El ektr oni k/FU und Starter/5. Par ameter/Par ameter auflistung (P000 ...)/P200- P299/Parameter P218 – Modulati onsgrad @ 0\mod_1327590589726_14638.doc x @ 14930 @ @ 1

Modulation depth

P218

(modulation depth)

50 ... 110 %

This setting affects the maximum possible output voltage of the VFD in relation to the line voltage.

Values <100% reduce the voltage to values below that of the line voltage if this is required for

{ 100 }

motors. Values >100% increase the output voltage on the motor. This leads to increased harmonics

in the current and can lead to oscillations in some motors.

Normally this should be set to 100%.

Pos : 359 /Allgemein/Allgemeingültig e Module/---------Seitenumbr uc h kompakt --------- @ 13\mod_1476369695906_0.doc x @ 2265496 @ @ 1

BU 0200 en-US-3118