Configure The Network From The Phone; Network Configuration Fields - Cisco 8800 Series Administration Manual

Configure the Network from the Phone

<?xml version="1.0" encoding="UTF-8"?>
<device>
<flat-profile>
<!-- System Configuration -->
<Profile_Rule ua="na">gds://</Profile_Rule>
<!--
<Upgrade_Enable ua="na">Yes</Upgrade_Enable>
<Upgrade_Error_Retry_Delay ua="na">3600</Upgrade_Error_Retry_Delay>
<Upgrade_Rule ua="na">http://<server ip address>/sip88xx.11-2-3MSR1-1.loads</Upgrade_Rule>
<!-- <BACKUP_ACS_Password ua="na"/> -->
</flat-profile>
</device>
Configure the Network from the Phone
The phone includes many configurable network settings that you may need to modify before it is functional
for your users. You can access these setting through the phone menus.
The Network configuration menu provides you with options to view and configure a variety of network
settings.
You can configure settings that are display-only on the phone in your Third-Party Call Control system.
Procedure
Step 1 Press Applications
Step 2
Select Network configuration.
Step 3 Use the navigation arrows to select the desired menu and edit.
Step 4
To display a submenu, repeat step 3.
Step 5 To exit a menu, press

Network Configuration Fields

Table 8: Network Configurations Menu Options
Field Field Type or
Choices
Ethernet
configuration
IP mode Dual mode
IPv4 only
IPv6 only
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
40
Firmware Upgrade -->
.
.
Default
Dual mode
Description
See the following Ethernet configuration submenu table.
Select the Internet Protocol mode for which the phone operates.
In dual mode, the phone can have both IPv4 and IPv6 addresses.
Cisco IP Phone Installation