Cisco 8800 Series Administration Manual page 268

Line Call Status
Parameter
Extended Function Status
Line Call Status
Parameter
Call State
Tone
Encoder
Decoder
Type
Remote Hold
Callback
Mapped RTP Port
Peer Name
Peer Phone
Duration
Packets Sent
Packets Recv
Bytes Sent
Bytes Recv
Decode Latency
Jitter
Round Trip Delay
Packets Lost
Loss Rate
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
252
Cisco IP Phone Troubleshooting
Description
Indicates whether extended function is enabled.
Description
Status of the call.
Type of tone that the call uses.
Codec used for encoding.
Codec used for decoding.
Direction of the call.
Indicates whether the far end placed the call on hold.
Indicates whether the call was triggered by a call back
request.
The port mapped for Real Time Protocol traffic for
the call.
Name of the internal phone.
Phone number of the internal phone.
Duration of the call.
Number of packets sent.
Number of packets received.
Number of bytes sent.
Number of bytes received.
Number of milliseconds for decoder latency.
Number of milliseconds for receiver jitter.
Number of milliseconds for delay in the RTP-to-RTP
interface round trip.
Number of packets lost.
The fraction of RTP data packets from the source lost
since the beginning of reception. Defined in
RFC-3611—RTP Control Protocol Extended Reports
(RTCP XR).