Configure The Audio Settings - Cisco 8800 Series Administration Manual

Cisco IP Phone Administration
Procedure
In a ring tone script, assign a name for the ring tone and add the script to configure a distinctive ringtone in
the format:
n=ring-tone-name;h=hint;w=waveform-id-or-path;c=cadence-id;b=break-time;t=total-time
where:
n = ring-tone-name that identifies this ring tone. This name appears on the Ring Tone menu of the phone. The
same name can be used in a SIP Alert-Info header in an inbound INVITE request to tell the phone to play the
corresponding ring tone. The name should contain the same characters allowed in a URL only.
h = hint used to SIP Alert-INFO rule.
w = waveform-id-or-path which is the index of the desired waveform to use in this ring tone. The built-in
waveforms are:
• 1 = Classic phone with mechanical bell
• 2 = Typical phone ring
• 3 = Classic ring tone
• 4 = Wide-band frequency sweep signal
You can also enter a network path (url) to download a ring tone data file from a server. Add the path in this
format:
w=[tftp://]hostname[:port]/path
c = is the index of the desired cadence to play the given waveform. 8 cadences (1–8) as defined in <Cadence
1> through <Cadence 8>. Cadence-id can be 0 If w=3,4, or an url. Setting c=0 implies the on-time is the
natural length of the ring tone file.
b = break-time that specifies the number of seconds to break between two bursts of ring tone, such as b=2.5.
t = total-time that specifies the total number of seconds to play the ring tone before it times out.

Configure the Audio Settings

The user can modify volume settings by pressing the volume control button on the phone, then pressing the
Save softkey.
Before you begin
Access the phone administration web page. See
Procedure
Step 1 Select Voice > User.
Step 2
In the Audio Volume section, configure a volume level of 1 (quiet) through 10 (loudest):
Access the Phone Web Page, on page
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
Configure the Audio Settings
88.
165