Configure The Sdp Payload Types; Configure The Sip Settings For Extensions; Configure The Sip Proxy Server - Cisco 8800 Series Administration Manual

Cisco IP Phone Installation

Configure the SDP Payload Types

Configured dynamic payloads are used for outbound calls only when the Cisco IP Phone presents a Session
Description Protocol (SDP) offer. For inbound calls with an SDP offer, the phone follows the caller's assigned
dynamic payload type.
The Cisco IP Phone uses the configured codec names in outbound SDP. For incoming SDP with standard
payload types of 0-95, the phone ignores the codec names. For dynamic payload types, the phone identifies
the codec by the configured codec names (comparison is case-sensitive).
Before you begin
Access the phone administration web page. See
Procedure
Step 1
Select Voice > SIP.
Step 2 In the SDP Payload Types section, set the value as specified in
• AVT Dynamic Payload—Any nonstandard data. Both sender and receiver must agree on a number.
Step 3
Click Submit All Changes.

Configure the SIP Settings for Extensions

Before you begin
Access the phone administration web page. See
Procedure
Step 1 Select Voice > Ext(n), where n is an extension number.
Step 2
In the SIP Settings section, set the parameter values as described in
Step 3 Click Submit All Changes.

Configure the SIP Proxy Server

Before you begin
Access the phone administration web page. See
Procedure
Step 1
Select Voice > Ext(n), where n is an extension number.
Ranges from 96 to 127. Default: 101.
Access the Phone Web Page, on page
Access the Phone Web Page, on page
Access the Phone Web Page, on page
Cisco IP Phone 8800 Series Multiplatform Phones Administration Guide
Configure the SDP Payload Types
88.
SDP Payload Types, on page
88.
SIP Settings, on page 321.
88.
279.
67