Adjustments - Keysight Technologies N5290/1A PNA Series Service Manual

System Tests and Adjustments

Adjustments

Adjustments
These adjustments are firmware-driven tests that are used to adjust your
N5290/1A mmW System or N5292A after PCA, cable, or connector has been
replaced.
If multiple adjustments are to be performed, perform them in the order listed.
N5290/1A System Only
Run these tests after the PNA, heads, or N5292A test set have been repaired
and the system is ready for final testing.
— LO Adjustment for mm Mode
— IF Gain Adj for mm Mode
— Source and Receiver Adj.
— Receiver Characterization
— IF Response Adj. for mm Mode
Keysight N5290/1A Service Guide 3-47