Keysight Technologies N5290/1A PNA Series Service Manual page 60

System Tests and Adjustments
N5292A Functional Verification Procedure
— "LO Power Calibration, Adjustment, and Verification" on page 3-24
— "Millimeter-wave (mmW) Heads Sense Voltage (Head Detect)" on
page 3-28
— "Millimeter-wave (mmW) Heads Sense Voltage (Head Detect)" on
page 3-28
— "S-Parameters (Insertion Loss/Match)" on page 3-31
— "Test Set Connector and Cable Verification" on page 3-40
LO Power Calibration, Adjustment, and Verification
STOP! This section assumes you have completed the PNA calibration. If
you have not ran the PNA calibration, refer to
and Loading the N5292A Test Set Functional Verification Software (Launch
Test)" on page
STOP!
If you know the test set is the faulty instrument, but the problem in the test
set has not been identified, skip to the
Sense Voltage (Head Detect)" on page
This section assumes you have already downloaded the Launch Test
application to your PNA. If not, refer to
Loading the N5292A Test Set Functional Verification Software (Launch
Test)" on page
Required when:
LOPA/LODA/Phase compensation/Test set mother board (TSMB) are changed.
The LO calibration is required only to be performed on one N5292A test set
port (e.g., the factory uses port 1). But, LO verify is required on all ports.
Equipment required:
— 26.5 GHz PNA-8 with Option 020
— ECal or Calibration kit with a minimum 26 GHz frequency
— LO Fixture (N5292-60127)
— PC with Launch Test application loaded (
Calibrate the LO on port one and run and verify all of the ports. Refer
Calibration (Pna Cal) and Loading the N5292A Test Set Functional
Verification Software (Launch Test)" on page
3-24
3-22.
3-22.
"PNA Calibration (Pna Cal)
"Millimeter-wave (mmW) Heads
3-28.
"PNA Calibration (Pna Cal) and
)
3-22.
Keysight N5290/1A Service Guide
to"PNA