N5290/1A Millimeter-Wave Test System Operator's Check; Performing The N5290/1 A System Operator's Check - Keysight Technologies N5290/1A PNA Series Service Manual

System Tests and Adjustments

N5290/1A Millimeter-wave Test System Operator's Check

N5290/1A Millimeter-wave Test System Operator's Check
STOP! This section assumes you have completed the N5292A test set
Operator's Check. If you have not completed the N5292A test set
Operator's Check, refer to
page
IMPORTANT! Before you begin any testing on a System or instrument,
always inspect the connectors on the instrument, the calibration kit,
cables and adapters.

Performing the N5290/1 A System Operator's Check

The N5290/1 A System Operator's Check is done to verify the system to isolate
the problem instrument or after the N5292A test set has been repaired and the
N5292A test Operator's Check has been completed. Refer to
Functional Verification Procedure" on page
To achieve the maximum system stability, allow the analyzer to warm up
for at least 15 minutes before performing the Operator's Check.
The operator's check is a software driven test that checks the basic operation
of the assemblies in all of the measurement port signal paths. By performing
the operator's check, the following are tested:
— attenuation ranges of all installed attenuators
— calibration of the receivers
— frequency response of the receivers
— phase lock and leveling
— basic functional test of noise floor and trace noise
Accessories Used in the Operator's Check
For more, refer to
Equipment Type
Female short, 1. 0 mm
Female open, 1. 0 mm
Keysight N5290/1A Service Guide
"N5292A Functional Verification Procedure" on
3-16.
"Required Service Test Equipment" on page
Part Number
(any short from the 85059B calibration kits)
(any open from the 85059B calibration kits)
"N5292A
3-16.
2-3.
3-41