Enabling Or Removing Options - Keysight Technologies N5290/1A PNA Series Service Manual

General Purpose Maintenance Procedures
Keysight License Manager

Enabling or Removing Options

There are two types of options:
— Hardware: Hardware options involve adding additional hardware to the
analyzer. After the proper hardware has been installed in the analyzer, the
appropriate license can be installed using the Keysight License Manager.
It is necessary to re-enable all installed hardware options, if the test set
mother-board is replaced.
— Software: Software options add features or functionality to the analyzer
without the need for additional hardware. These options are enabled by
installing the appropriate licenses using the Keysight License Manager
(KLM). Refer to
http://literature.cdn.keysight.com/litweb/pdf/N5242-90024.pdf
Some applications require a license key file that is provided by Keysight. If
you do not have the required license key file, contact Keysight for
assistance. Refer to
To enable or remove an option:
1. Start the Keysight Software Manager. Refer to
License Manager" on page
2. In the Keysight License Manager window that opens, in the left hand
column, press local host > Local Licenses. A list of available options,
similar to the list below, will appear. Refer to
S93015A - Dynamic uncertainty for S-parameters
S93025A - Basic pulsed-RF measurements
029 - Noise figure measurements
S93086A - Gain Compression Application
S93087A- IMD Measurements
029 - Full Noise Measurements
219 - Src/Rcvr Atten & Bias Ts 2-Port
419 - Src/Rcvr Atten & Bias Ts 4-Port
224 - 2nd Src w/Combiner & Switches
423 - Combiner & Switches
3. Press and hold (or right click with a mouse) the option that you wish to
either enable or remove, and then click Install or Delete, whichever is
appropriate.
Keysight N5290/1A Service Guide
"Contacting Keysight" on page
8-4.
2-7.
"Accessing the Keysight
Figure 8-2 on page 8-4.
8-5