System Tests and Adjustments
Adjustments
Accessories Used in the Adjustments
For more, refer to
Equipment Type
Calibration and Verification Tools
1.0 mm calibration kit
ECal module (Recommended, but not required)
Power supply load ET
LO Cal and RF Eterm ET
WBIF and LFE Eterm ET
Cables
System cable
Cables (x6)
3.5 mm (m) to 3.5 mm (m)
GPIB cable
Adapters
Female short, 1.0 mm
Female open, 1.0 mm
Female to Male thru, 1.0 mm
1.00 mm (f) to 1.00 mm (f) (short thru)
SMA (m) to SMA (f) elbow adapters
SMA (m) to SMA (f) thru adapters (x8)
a. This is a short thru that is not included in hte 85059B calibration kit.
b. Use x3 for front panel wideband IF and LFE Eterms.
c. Use x5 as connector savers on the rear panel IF ports (optional). Use x3 for front panel wideband IF and
LFE Eterms.
3-48
"Required Service Test Equipment" on page
Part Number
85059B
N4691B
300 kHz to 26.5 GHz
ET57265
ET57259–1
ET57259–2
N4011-21002
N5240-60092
Z5623A-K20
10833B
(any short from the 850598 calibration kit)
(any open from the 850598 calibration kit)
(from the 85059B calibration kit) LO ET
11920–60002
1250-2818
b
1250-3851
c
a
Keysight N5290/1A Service Guide
2-3.