Chapter 3
Installing Modules and Cables in the Chassis
Figure 3-9
1 Cable-Management Bracket
Insert and tighten the captive screw(s) to secure the bracket. (see
Step 3
Connect all the cables to the intended ports and pass them throught the cable management bracket in an
Step 4
organized manner.
Removing a Cable-Management Bracket
To remove a cable-management bracket, follow these steps (see
Step 1
Attach an ESD-preventive wrist or ankle strap and follow its instructions for use.
Step 2
Note the current interface cable connections to the ports on the RP.
Step 3
Starting with the interface cable for the bottom port on the RP, disconnect the cable from the RP
interface.
Step 4
Repeat
to
Step
Loosen the captive installation screw on the cable-management bracket and remove the bracket from the
Step 5
chassis (see
OL-26701-02
Cable-Management Bracket Installation and Removal
Step 3
for all remaining interface cables, proceeding from the bottom ports upward, then proceed
5.
Figure
3-9).
Cisco ASR 9001 and Cisco ASR 9001-S Routers Hardware Installation Guide
Cable Management
Figure
3-9).
Figure
3-9):
1
3-15