Installing The Cable Management Bracket On An Mio Or Umio Card - Cisco ASR 5500 Installation Manual

▀ Installing the Cable Management Bracket on an MIO or UMIO Card

Installing the Cable Management Bracket on an MIO or UMIO
Card
The cable management bracket is packaged in the MIO/UMIO shipping box.
Ideally, the bracket should be installed on an MIO/UMIO before it is installed in the ASR 5500 chassis. However, you
can safely install the bracket on an MIO/UMIO in a powered-up ASR 5500 chassis.
No tools are required to install the bracket.
Caution:
jack located at the upper left corner of the chassis.
To install the bracket:
Step 1
Locate the bracket and its mounting hardware (two nylon pin-and-sleeve connectors).
Step 2
Position the bracket on the faceplate of the MIO/UMIO as shown in the figure below.
Step 3
Insert a nylon sleeve in both holes of the bracket and into the MIO/UMIO faceplate.
Step 4
Use your thumb to firmly push a nylon pin into each sleeve to secure the bracket to the faceplate.
Caution:
attempt to lift an MIO/UMIO or remove an MIO/UMIO from the chassis by grasping the bracket.
▄ ASR 5500 Installation Guide
156
Observe ESD precautions when handling the MIO/UMIO. Wear a ground strap connected to the ESD
The cable management bracket is not designed to be used as a handle for the MIO/UMIO. Never
Cable Management System Installation