Table of Contents
Advertisement
Chapter 11: Cabling Copper and SFP+ Ports
Installing 1Gbps SFP and 10Gbps SFP+ Transceivers
152
This section contains installation instructions for SFP and SFP+
transceivers. The transceiver in the illustrations has a duplex LC
connector. Your transceivers may have different connectors. To install
transceivers, perform the following procedure:
1. Select an SFP+ port for the transceiver.
2. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
3. Position the transceiver with the Allied Telesis label facing up. Refer to
Figure 77.
Figure 77. Installing an SFP+ Transceiver
4. Slide the transceiver into the port until it clicks into place.
Note
If you are ready to attach the fiber optic cable to the transceiver,
continue with the next step. Otherwise, repeat steps 1 to 4 to install
a second transceiver in the switch.
5. Remove the dust cover from the transceiver, as shown in Figure 78 on
page 153.
Advertisement
Table of Contents
