Pego Vision Touch Wellness User And Maintenance Manual page 78

Table of Contents

Advertisement

VISION TOUCH WELLNESS
- LAN Connection
If connected to a LAN where a DHCP server is present (and the DHCP solicitude is
enabled on the Vision Touch, look at chap. 8.3.7), the Vision Touch will acquire a free IP
address. In this case it is possible to consult the IP address acquired through the "Info
Page" that you find in the "Web server" menu of the Vision Touch.
If the DHCP is not present, Vision Touch maintains the IP address set in the configuration
of the parameters.
Pay attention: in this case, IP conflicts with other devices connected to the LAN could be
possible.
In order to connect to the Vision Touch, i twill be necessary to connect your own device to
the same net, in DHCP mode, or with compatible static IP, open up a browser and digit in
the address bar the following order:
http://hostname/
where
hostname
=
unique
identifier linked to the serial number present in the
info page (look at "Info Page", chap. 8.3.7).
or
(Vision Touch IP address, look at "Info Page", chap. 8.3.7)
http://XXX.XXX.XXX.XXX/
NOTE: The Host name of the Vision Touch is a unique reference linked to the serial
number. So that it is possible to connect different Vision Touch devices using the same
LAN net, setting distinct IP addresses in case that a DHCP server is not available.
For if you desire to join the Vision Touch from the web browser, it is sufficient to write in
the address bar:
http://vt_xxxxxxxxxx/
Where xxxxxxxxxx = serial number of the device
USER AND MAINTENANCE MANUAL
Pag. 78
Rel 01-19

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Vision Touch Wellness and is the answer not in the manual?

Table of Contents