Pego Vision Touch Wellness User And Maintenance Manual page 56

VISION TOUCH WELLNESS
The "Software" menu allows to perform maintenance on the device software. The menu
can be accessed from the main Configuration page ("Parameters" Button). The display of
this item can be set in the "Password" sub-menu => "Configure user level menu" and by
selecting the "Software" item (installer login required).
Software
Software update
Reload factory values
Clone machine configuration
Repair EEPROM
Repairing errors in the internal
memory of the control unit
Software updating procedure:
Copy the update file "VT_ WEL _#_#_#_#.pego" (the symbols # represent the
-
progress of the version) to an empty USB pen drive. Only the update file must be
present in the pen drive.
Insert the USB pen drive in the USB1 port of the controller (the symbol
-
inserted and acknowledged appears on the status bar).
Press the "Update software" button.
-
The device proceeds to update autonomously, performing the following steps (the
-
operation requires a few minutes): it exports the programs and configurations (if
applicable) > it deletes the internal memory and installs new software > it restores the
programs and configurations (if applicable) > it restarts the VISION TOUCH
WELLNESS.
USER AND MAINTENANCE MANUAL
Pag. 56
Software
Restore all default settings
The execution of the program in progress is interrupted but the stored
programs are not deleted.
Exporting/importing the parameters
.
configuration from USB / SD
Rel 01-19
8.3.14
of USB