Distributing The Sealant; Checking The Tire Inflation Pressure - Kia XCeed 2020 Owner's Manual

What to do in an emergency
Only use the front passenger side
power outlet.
10. W ith the ignition switched
on or ENGINE START/STOP
button position on: Switch on
the compressor and let it run
for approximately 3 minutes
to fill the sealant. The inflation
pressure of the tire after filling is
unimportant.
11. S witch off the compressor.
12. D etach the hose from the
sealant bottle connector and
from the tire valve.

Distributing the sealant

• Immediately drive approximately
7~10km (4~6miles or, about
10min) to evenly distribute the
sealant in the tire.
Return the Tire Mobility Kit to its
storage location in the vehicle.
WARNING
Carbon monoxide poisoning and
suffocation is possible if the engine
is left running in a poorly ventilated
or unventilated location (such as
inside a building).
CAUTION
Do not exceed a speed of 60 km/h
(35 mph). If possible, do not fall
below a speed of 20 km/h (12 mph).
IF YOU HAVE A FLAT TIRE (WITH TIRE MOBILITY KIT)
While driving, if you experience any
unusual vibration, ride disturbance or
noise, reduce your speed and drive
with caution until you can safely pull
off of the side of the road. Call for
road side service or towing.
When you use the Tire Mobility
Kit, the wheel may be stained
by sealant. Therefore, remove
the wheel stained by sealant
and have the vehicle inspected
at a professional workshop. Kia
recommends to visit an authorized
Kia dealer/service partner.

Checking the tire inflation pressure

1. After driving approximately
7~10 km (4~6 miles or about
10 minutes), stop at a suitable
location.
2. Connect the filling hose (3) of the
compressor (clip mounted side)
directly and then connect the
filling hose (3) (opposite side) to
the tire valve.
3. Connect between compressor and
the vehicle battery using the cable
and connectors.
4. Adjust the tire inflation pressure
to 200 kPa (29 psi). With the
ignition switched on, proceed as
follows.
- To increase the inflation
pressure: Switch on the
compressor, position I. To check
the current inflation pressure
7
7 35