Kia XCeed 2020 Owner's Manual page 38

Safety features of your vehicle
This could result in loss of control,
and an accident causing death,
serious injury, or property damage.
Storing positions into memory
using the buttons on the door
Storing driver's seat positions
1. Shift the shift lever into P or N
(for Dual clutch transmission
and Automatic transmission) or
Neutral (for Manual transmission)
while the ENGINE START/STOP
button is ON or ignition switch ON.
2. Adjust the driver's seat
comfortable for the driver.
3. Press SET button on the control
panel. The system will beep once.
4. Press one of the memory buttons
(1 or 2) within 4 seconds after
pressing the SET button. The
system will beep twice when
memory has been successfully
stored.
Recalling positions from memory
1. Shift the shift lever into P or N
(for Dual clutch transmission
and Automatic transmission) or
Neutral (for Manual transmission)
while the ENGINE START/STOP
button is ON or ignition switch ON.
2. To recall the position in the
memory, press the desired
memory button (1 or 2). The
system will beep once, then the
3 10
driver's seat will automatically
adjust to the stored position.
Adjusting the control switch for
the driver's seat while the system
is recalling the stored position will
cause the movement to stop and
move in the direction that the
control switch is moved.
WARNING
Use caution when recalling the
adjustment memory while sitting in
the vehicle. Push the seat position
control switch to the desired position
immediately if the seat moves too
far in any direction.
Initializing Driver position memory
system
Initialize Driver position memory
system as follows if the system fails
to function properly.
Initialization method
1. Have the vehicle completely
stopped, the ignition [ON], and the
shift lever placed into P (Parking).
Afterwards, open the door on
driver's side.
2. Using the control switches for
forward or backward and seatback
angle, pull the seat forward to the
fullest and the seatback upright
forward to the fullest.
Seats