Encoder Cable Break Control Function - gefran SIEIDrive LIFT AGy -L Instruction Manual

8.4 Encoder cable break control function

The encoder cable break control function is available from card EXP-ENC-AGy rev. C with fw 3.04 and later.
To enable the function, set parameter I.506 Enc fault enable = 1 (Enabled)
Note!
For instructions on how to connect single-channel encoders and enable the encoder cable break control
function and for details of electrical specifications and configurations, please see the manual supplied with the
EXP-ENC-AGy card.
AGy -L 85