Profinet Io - Siemens SIRIUS M200D Manual

4.2.8.2

PROFINET IO

Introduction
You connect the supply voltage and PROFINET IO at the M200D PROFINET
communication module. The communication module is equipped with a PROFINET switch
This allows direct looping through of PROFINET IO, or the direct connection of a further IO
device.
Figure 4-8
PROFINET
Modules with PROFINET interfaces may only be operated in LANs (Local Area Network) in
which all nodes are equipped with SELV / PELV power supplies or protection systems of
equal quality.
A data transfer terminal (modem, for example) is required to access the WAN (Wide Area
Network) in order to ensure compliance with this safety standard.
M200D PROFIBUS/PROFINET
Manual, 08/2014, A5E01577426A/RS-AA/004
PROFINET IO communication module
-X33 7/8" circular socket connector (with pin insert) for infeed of the DC 24V-NS
24V DC electronic/encoder supply and the DC 24V-S load voltage supply
-X34 7/8" circular socket connector (with socket insert) for looping through the
24V DC DC 24V-NS electronic/encoder supply and the DC 24V-S load voltage supply
-X31 M12 circular socket connector (with socket insert) for connection of PROFINET IO
P1
-X32 M12 circular socket connector (with socket insert) for connection of PROFINET IO
P2
CAUTION
Mounting / connection
4.2 Connection
115