Siemens SIRIUS M200D Manual page 61

Settings
Device parameter
Output level 1
Output level 2
Output 1 signal
Output 2 signal
Output 1 action
Output 2 action
1) Brake output only on starters with BO
2) Run-up, operation/shunting, coasting down only on soft starters.
Messages and actions
Output 1 active
Output overloaded
Output BO (brake output) active
M200D PROFIBUS/PROFINET
Manual, 08/2014, A5E01577426A/RS-AA/004
Default setting
Not inverted
Continuous signal
Control source
PIO DO 1.0
Control source
PIO DO 1.1
Message
Setting range
Not inverted
•
Inverted
•
Continuous signal
•
Flashing
•
Triggering by means of external control source
Control source PIO DO 1.0
•
(output 1)
Control source PIO DO 1.1
•
(output 2)
Control source PIO DO 0.2
•
(brake output)
Control source input 1
•
Control source input 2
•
Control source input 3
•
Control source input 4
•
Actuation by motor starter
Run-up
•
2)
Operation/shunting
• 2)
Coasting down
• 2)
On time motor (RUN)
•
Control command motor ON
•
Brake output
•
Device ON
•
Actuation by messages from the motor starter
Group prewarning
•
Group warning
•
Group fault
•
Bus error
•
Device error
•
Maintenance required
•
Maintenance requested
•
Ready for motor ON
•
Action
The output is controlled
Tripping (acknowledgment via trip reset)
The brake output is controlled
Functions
3.7 System monitoring
1)
61