Prefabricating Power Cables - Siemens SIRIUS M200D Manual

Mounting / connection
4.2 Connection
4.2.3

Prefabricating power cables

To prefabricate power cables, you require the following:
● A crimping tool for attaching the sockets and pins on the individual wires
● For infeed on motor starters
Assignment of X1: see section Power terminal (Page 106):
– A flexible Cu cable with 4 x 2.5 mm
– Han Q4/2 socket power connector
Item
Contact socket 2.5 mm
Contact socket 4 mm
Contact socket 6 mm
Crimping tool 4 / 6 mm²
Consumer connection on the motor starter
For the assignment of X2, see Power terminal (Page 106):
● A flexible Cu cable with 1.5 mm
– Without brake control: 3 wire + PE
– With brake control: 5 wire + PE
– With temperature sensor: 2 additional wires
– Han Q8/0 pin power connector
Item
Connector set, 8 X 1.5 mm
Connector set, 8 X 2.5 mm
104
(for motor starters with 230 V AC brake output: 5-core cable; 3 wire + N + PE)
, for Han Q4/2 sockets
2
, for Han Q4/2 sockets
2
, for Han Q4/2 sockets
2
, 9 pin, complete with PG16 cable entry
2
, 9 pin, complete with PG16 cable entry
2
/ 4 mm / 6 mm
2 2
or 2.5 mm
2 2
Manual, 08/2014, A5E01577426A/RS-AA/004
(3 wire + PE)
2
Quantity Order no.
5 3RK1911-2BE50
5 3RK1911-2BE10
5 3RK1911-2BE30
1 3RK1902-0CW00
Order no.
3RK1902-0CE00
3RK1902-0CC00
M200D PROFIBUS/PROFINET