Siemens SIRIUS M200D Manual page 213

Object Byte.Bit Parameters / content
No.
163 96 Output 1 action
164 97 Output 2 action
230 137.0 ... 3 Connector monitoring
231 137.4 ... 7 Response when
connector removed
BO: Brake output
1)
M200D PROFIBUS/PROFINET
Manual, 08/2014, A5E01577426A/RS-AA/004
Range of values
[00]: No action
[01]: Control source PIO DO 1.0
[02]: Control source PIO DO 1.1
[03]: Control source PIO DO 0.2
[06]: Control source input 1
[07]: Control source input 2
[08]: Control source input 3
[09]: Control source input 4
[10]: Run-up
[11]: Operation/shunting
[12]: Coasting down
[13]: On time motor (RUN)
[14]: Control command motor
(ON)
[17]: Brake output
[18]: Device ON
[30]: Group prewarning
[31]: Group warning
[32]: Group fault
[33]: Bus error
[34]: Device error
[35]: Maintenance required
[36]: Maintenance requested
[38]: Ready for motor ON
[00]: No action
[01]: Control source PIO DO 1.0
[02]: Control source PIO DO 1.1
[03]: ...[38]: See byte 96
[0]: Deactivated
[1]: Line side
[0]: Group fault
[1]: Group fault only after ON
command
[2]: Group warning
A.1 Data formats and data sets
Increment Default
setting
— [01]
— [02]
— [0]
— [0]
Appendix
Relevant for
All starters
All starters
All starters
All starters
All starters
All starters
All starters
All starters
sDSS../sRSS..
sDSS../sRSS..
sDSS../sRSS..
All starters
All starters
With BO only
All starters
All starters
All starters
All starters
All starters
All starters
All starters
All starters
All starters
All starters
All starters
All starters
All starters
All starters
213