Led Display Combinations - Siemens SIRIUS M200D Manual

Diagnostics
7.1 Diagnostics with LED
7.1.2

LED display combinations

Additional diagnostics options are created from combining the indicator statuses:
Device status / operating mode
SF LED
Off
Off
Off
Off
Off
Off
Off
Off
Off
Off
Device error
Note
Acknowledging device errors
A device error can only be acknowledged by switching the power off and then on again.
If the error occurs again, however, the motor starter must be replaced.
SF LED
Red
Red
144
STATE LED DEVICE LED
Green Green
Off Green
Flashing green Green
Flashing green Green
Flickering green Green
Flashing yellow Green
Flickering Green
yellow
Off Flickering red
Off Green flashing (1 s / 1 s)
Off Green flashing
(0.25 s / 1.75 s)
STATE LED DEVICE LED
Red Red
Off Red
Device status / operating mode
Motor ON; no fault
Motor OFF; no fault
Motor in soft start-up; no fault
(sDSSte, sRSSte only)
Motor in soft run-down; no fault
(sDSSte, sRSSte only)
Motor on; input controls
Manual mode connection interruption
without reset to automatic mode
Tripping by input control function
(e.g. quick stop)
Self-test in progress
No start-up parameters received
Energy-saving mode active
Device error
Current flowing with no ON command
(e.g.: contact welded, thyristor failure)
Electronics defective, self-test error
Manual, 08/2014, A5E01577426A/RS-AA/004
M200D PROFIBUS/PROFINET